The conversion to E85 required injectors capable of flowing close to 1000cc per minute. Side feed injector options are very limited so end feed injectors were used. I settled on the Bosch EV14 injector.
Bosch part number: 0 280 158 040
980cc/min = 670g/min = 89lb/hr @ 3bar
Single cone spray
Compact body length
Extended tip nozzle
12 ohm resistance
I wasn't sure if the long nose on these injectors was going to cause an issue but it turns out they are a very nice fit inside the manifold. They poke out a little more than the original side feed injectors but not far enough to interfer with theair flow. The pictures below are taken looking back into the intake manifold.